Видео

이 영상을 보고 있는 현재 나는 2011 mk6 gti를 타고 있으며 320,000km를 주행중이다. 나의 엔진은 cczb로 알고 있으며 현재까지 타이밍텐셔너에 문제 없이 잘 사용중이다. 개인적으로 나는 ea888엔진은 잘 만든 엔진이라고 생각합니다.

This is my car engine. Thanks for sharing.first time here.

Good morning, Following a centralization problem on the front driver's door of my BMW F20, I changed the electronic lock without touching the cylinder. the centralization of the door works again except that now it is the manual opening/closing (emergency procedure with the key) which no longer works. do you know where it could come from? THANKS

had replacement stickers of these guys utter rubbish peel within week not tamper proof its just a vinyl print AVOID AVOID AVOID

Thank you

Great video. Terrible engineering

I changed the coil and plugs still the engine is shaking

I bought a Nissan juke last year 18/05/2023 i applied for V5C after i wated for 9 months DVLA replied me that the police will come to check the car am waiting for the police to come no sign i went to police station twice they told me to wait for the police...am so depressed i save money working for NHS as a health care support work to buy this car just to drive to work and help patients. But see my story is very sad am passing through this 😢

Balance shaft? lol! That’s Balenciaga my friend!

Sounds a lot like that could be timing chain slap.

Where you buy the vin stickers ?

I don't know what's wrong with this gen 3 engine it's a bit noisy! I drove it 6000 miles and only had to put 1 liter of oil in. You are supposed to change the oil every year dumbass, do you think that might have something to do with the noise?

Surprising that the thieves didnt take lumps out of that car to search for a tracker.

What year and car Audi model are you working on?

Where did you bought VIN sticker from ?

I just want to get the front balance shaft out. Could I just remove the water pump belt cover and the impeller to get that bolt and sprocket off the end of the balance shaft without removing the entire water pump?

I have 1st motor it started burning oil on 154 000 km . Got advice use SHELL HELIX oil oil consumtion stoped . No CASTOR OIL FOR ME NEVER AGAIN.

what are the tightening torques for main bearing and rod bearings for mercedes benz C200 CGI W271.86 W204

Tree years after the video there are legit questions but no one to answer them, what a pity. Still dont know for sure it the gen 3, 3b can be considered safe and reliable in the long run...

i just did mine, thank you so much

Mark 8s with the 2.0 TSI have the Evo4 engine. Slightly bigger turbo (not from IHI anymore). Cylinder block is cast iron on all EA888, one of the best traits of it.

Thanks for the video, getting done today

In this video you compared the noise after with the engine noise surpression cover on,so not like for like. In the before comparison the engine cover is off. Not a very fair or good comparison.

Thought bwa engine was gen 1 found in gti mk5 🤔

Troll video

Very nice video m8 well done! Brother! 🎉

hi, I have a question, my speakers on the left side of the car are creaking, I changed them to new ones and it's still the same, do you think where to look for the fault in the radio or main unit?

Hi thanks for the video, could you please tell me where you bought the vin plate from?

Seriously audi really have a lot of bullshit ticking issues

Pls i need help 🙏 I bought cat S car and without log book. Seller told me he bought this from auction. I applied for V5 , then DVLA asked me to give pictures of thecar and close up reg numbers,VIN numbers. I found chessi number(INgraved in to metal when open the bonet)is different from windscreen and door VIN. I went to the police to check they said this car is stolen car and some one put cat s number plate and VIN number to windscreen and door. I did the bank transfer . Whats mu rights to keep the car. I got the proof of purchase. Please advise me. I m in very stressful situation

Hey brother, this is some great stuff on your channel. I hope that you can really answer my question. I just changed the balance shaft chain on this engine that goes around the other 3 sprockets but didn’t notice that they have indents on them as if they were timing marks. How do I go about orienting these 3 gears to their proper positions? Thank your time brother.

Mine was replaced under warranty at my not 37k miles. Audi A6 C8

I’m choosing between i20n and 2020 polo gti What’s your optioning please for less problems

I cant get past the registration, it shows l am connected to the device... But then there is no next to the app. Just keeps bringing me back to the registration crap.

Hello I have a 2010 c300 good alternator but not charging.does this box have a fuse for the alternator?

My mmi unit doesnt come out after inserting the key, what do i do?

Can you leave it in the car, and use it while driving the car, to display the car information on an Android screen?

Great video , you are very informed and passionate about this ea888 engines . Well done, very useful info. Keep up the good work

is it possible to swap engines, replacing gen 1 with a gen 2 in the same car

Do you know why these engines rattle at colt start although the timing chain and tensioner were new?

Thank you so much for the video, very imformative. But now I wonder what things the EA888 EVO4 has been improved compared to the Gen3.

Hello my friend i want help for change digital cockpit

No idea where you are in the engine. I saw an alternator, that's my best guess is it's near there, but where exactly?

sorry so what is the problem of 2020 Q5 45tfsi 2.0T EA888? thanks

Arent cdnc is gen 2?

thank you

Does this do BSM reset?

can you rebuild gen1 with gen3 components? are they compatible?

thanks for nice try but just not clear at all. sorry

0